CCD-TR618, CCD-TR618E, CCD-TR718E, CCD-TR728E, CCD-TR818, CCD-TRV49, CCD-TRV49E, CCD-TRV58, CCD-TRV58E, CCD-TRV59E, CCD-TRV68, CCD-TRV78, CCD-TRV78E, CCD-TRV88, CCD-TRV98, CCD-TRV98E - Sony Movie Service Manual (repair manual). Page 8

Read Sony CCD-TR618 / CCD-TR618E / CCD-TR718E / CCD-TR728E / CCD-TR818 / CCD-TRV49 / CCD-TRV49E / CCD-TRV58 / CCD-TRV58E / CCD-TRV59E / CCD-TRV68 / CCD-TRV78 / CCD-TRV78E / CCD-TRV88 / CCD-TRV98 / CCD-TRV98E Service Manual online

— 8 —
SERVICE NOTE
1.
POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied (8.4V) to the
battery terminal using the service power cord (J-6082-223-A), the
power is shut off so that the unit cannot operate.
This following method is available to prevent this.
Method:
Use the DC IN terminal. (Use the AC power adaptor.)
7
Pull the timing belt in the direction of 
arrow 
A
 with a pincette while pressing 
the cassette compartment (take care 
not to damage) to adjust the bending 
of a tape.
8
Let go your hold the cassette 
compartment and rise the cassette 
compartment to take out a cassette.
Pincette
Timing belt
Timing belt
Press the cassette compartment not to 
rise the cassette compartment
[DC power supply]
(+5V)
Adjust the bending of a tape
Disconnect CN704
of VC-251 board.
Loading motor
A
A
2.
TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1
Refer to 2-3. to remove the front panel assembly.
2
Refer to 2-5 (TR model). or 2-6 (TRV model). to remove the
cabinet (R) assembly.
3
Open the control switch block (FK-1000).
4
Refer to 2-4. to remove the cabinet (L) assembly.
5
Disconnect CN704 (8P) of VC-251 board.
6
Add +5V from the DC POWER SUPPLY and unload with a
pressing the cassette compartment.
Page of 127
Display

Click on the first or last page to see other CCD-TR618 / CCD-TR618E / CCD-TR718E / CCD-TR728E / CCD-TR818 / CCD-TRV49 / CCD-TRV49E / CCD-TRV58 / CCD-TRV58E / CCD-TRV59E / CCD-TRV68 / CCD-TRV78 / CCD-TRV78E / CCD-TRV88 / CCD-TRV98 / CCD-TRV98E service manuals if exist.