CPD-E200 - Sony Monitor Service Manual (repair manual). Page 13

 

1

 Turn up one side of the rubber cap in

the direction indicated by arrow  a .

3

 When one side of the rubber cap

separates from the anode button,
the anode cap can be removed by
turning the rubber cap and pulling
it in the direction of  arrow  c .

 

2

 Use your thumb to pull the rubber

cap firmly in the direction indicated
by arrow  b .

WARNING: High voltage remains in the CRT even after the power is disconnected.  To avoid electric shock, discharge CRT

before attempting to remove the anode cap.  Short between anode and CRT coated earth ground strap.

NOTE:

After removing the anode, short circuit the anode of the picture tube and the anode cap to either the metal
chassis, CRT shield, or carbon painted on the CRT.

1

 Do not use sharp objects which may cause damage to the

surface of the anode cap.

2

 Do not squeeze the rubber covering too hard to avoid damag-

ing the anode cap. A material fitting called a shatter-hook ter-
minal is built into the rubber.

3

 Do not force turn the foot of the rubber cover. This may cause

the shatter-hook terminal to protrude and damage the rubber.

High voltage remains in the CRT even
after the power is disconnected.  To
avoid electric shock, discharge CRT
before attempting to remove the anode
cap.  Short between anode and CRT
coated earth ground strap.

Coated Earth

Ground Strap