CPD-220GS - Sony Monitor Service Manual (repair manual). Page 6

6

The supplied Macintosh adapter is compatible with Macintosh LC,
Performa, Quadra and Power Macintosh series computers.
Macintosh II series and some older versions of Power Book models
may need an adapter with micro switches (not supplied).

Do not short the pins of the video signal cable.

With the monitor switched off, connect one end of the
power cord to the monitor and the other end to a power
outlet.

The installation of your monitor is complete.

If “OUT OF SCAN RANGE” or “NO INPUT SIGNAL” appears on
the screen, see “Warning Messages” on page 18.

Install the new model information from the “Windows

®

 Monitor

Information Disk” into your PC.

If you need to change the OSD language, see “Selecting the
on-screen display language” on page 15.
The default setting is English.

Before using this monitor, check that the following items are
included in your carton:
• Monitor (1)
• Power cord (1)
• Macintosh adapter (1)
• Windows

®

 Monitor Information Disk (1)

• Warranty card (1)
• These operating instructions (1)
• Audio miniplug cord (1)

This monitor works with any IBM or compatible system
equipped with VGA or greater graphics capability.
Although this monitor works with other platforms running
at horizontal frequencies between 30 and 85 kHz including
Macintosh and Power Macintosh systems, a cable adapter is
required. Please consult your dealer for advice on which
adapter is suitable for your needs.

With the computer switched off, connect the video signal
cable to the computer’s video output.

7

Press the >?// buttons to adjust the volume.

The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.

To reset, press the RESET button while the OSD is on.

Press the MUTING button.
No sound comes from the speaker.
The 

mark appears at the bottom of the screen.

To cancel, press the MUTING button again.

You can listen to the audio signals from your computer
using headphones (not supplied). The speaker turns off
when headphones are connected to the headphones jack.
Adjust the volume using the SOUND OSD.

If the volume from the speaker was too low, you can adjust the
input level (average of 500 mv) by the computer.

AUDIO

IN

2

MENU

EXIT

CENTER

SIZE

GEOM

COLOR

SOUND

ZOOM

SCREEN

OPTION

OK

MENU

MENU

SOUND

26

MUTING

You can listen to music, sounds, and other audio files using
the speaker in your monitor.
Connect the AUDIO IN jack to the audio out jack of your
computer’s sound card using the miniplug cord (supplied).

Press the MENU button.
The MENU OSD appears.

Press the ¨./> and >?// buttons to select
“™ SOUND,” and press the MENU button again.
The SOUND OSD appears.

While muting the sound, the 

mark appears in the SOUND OSD

instead of the Á mark. Increase the volume to cancel the 

mark

and activate the speaker.