CPD-210EST, CPD-210GS - Sony Monitor Service Manual (repair manual). Page 13

3

When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow 

c

.

1

Don’t hurt the surface of anode-caps with shartp shaped material!

2

Don’t press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.

3

Don’t turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,

after removing the anode.

1

Turn up one side of the rubber cap in
the direction indicated by the arrow 

a

.

2

Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow 

b

.

2-2

1

2

     Two screws

(+BVTP 4 x 16)

     A board

     Neck assy

     Four screws

(Tapping screw 5)

     Deflection yoke

     Picture tube

     Anode cap

Cushion

Bottom cover
(D board)

     Stand assy

3

Claw

6

Claw

4

5

     Two screws

(+BVTT 4 x 8)

7

13

12

8

9

     Picture tube 

shield

11

10

Connector
(2pin)

CN506

CN501

CN603

GND

GND

CN307