Read Sony CPD-2001G Service Manual online
CPD-2001G
4-2
Connect the communication cable of the computer to the connector located on the D board on the monitor. Run the service software and
then follow the instruction.
then follow the instruction.
• Convergence Rough Adjustment
1. Enter the white crosshatch signal (white lines on black).
2. Adjust roughly the horizontal and vertical convergence at
2. Adjust roughly the horizontal and vertical convergence at
four-pole magnet.
3. Adjust roughly HMC and VMC at six-pole magnet.
Standard: ± 0.1mm (In the center of screen)
4. Make rough adjustment of the H direction convergence by
usig H. STAT VR (RV001 of A board).
Fig. 1
• Convergence Specification
• White Balance Adjustment Specification
(1) 9300K
x = 0.283 ± 0.005
y = 0.298 ± 0.005
y = 0.298 ± 0.005
(2) 5000K
x = 0.345 ± 0.005
y = 0.358 ± 0.005
y = 0.358 ± 0.005
• Vertical and Horizontal Position and Size
Specification
<6 Pole Magnet>
Fig. 4
Fig. 3
Fig. 5
• Focus adjustment
Adjust the focus volume 1 and 2 for the optimun focus.
Tab B
Tab A
Adjust HMC
Adjust VMC
IBM AT Computer
as a Jig
1-690-391-21
1
A-1500-819-A
Interface Unit
Interface Unit
2
*The parts above ( ~ ) are necessary for DAS adjustment.
1
3
D-sub
(9 Pin [female])
(9 Pin [female])
mini Din
(8Pin)
(8Pin)
4 Pin
3-702-691-01
Connector Attachment
Connector Attachment
3
To BUS CONNECTOR
4 Pin
4 Pin
XBV
XCV
B
R
B
R
R
B
B
R
H. TILT
YBH
TLV
R B
YCH
B
R
R
B
B
R
B
B
A
312 mm
B
MODE
All mode
234 mm
a
≤
3.0 mm
b
≤
2.5 mm
a
B
A
b
Purity
4-pole Mg
4-pole Mg
6-pole Mg
XCV
TLH
TLV
YCH
Fig. 2
FOCUS 1
FOCUS 2
B
A
A
0.30 mm
B
MODE
All mode
0.30 mm
Click on the first or last page to see other CPD-2001G service manuals if exist.