Read Sony DVP-PR30 / DVP-PR50P / DVP-PR60P Service Manual online
2-2
DVP-PR30/PR50P/PR60P
2-3. BASE UNIT (BU) DISASSEMBLY
(DEVICE, OPTICAL KHM-313AHC/C2RP)
Caution Point on the Laser Diode:
Laser Diode in the optical Device is very sensitive to Surge Current
or ElectroStatic Discharge (ESD):
Laser Diode in the optical Device is very sensitive to Surge Current
or ElectroStatic Discharge (ESD):
After take-out FMO-016 Flat Flexible Cable from CN101 of
MV-64/65 board immediately ground FMO-016 Flat Flexible
Cable pattern using short clip. Metal paper clip can be used as
short clip.
MV-64/65 board immediately ground FMO-016 Flat Flexible
Cable pattern using short clip. Metal paper clip can be used as
short clip.
Note:
Solder shortland before remove the
FMO-016 Flat Flexible Cable from
24 pin BU connector.
FMO-016 Flat Flexible Cable from
24 pin BU connector.
4
Two Insulator
4
Two Insulator
1
Clip FFC
3
Four Insulator Screws
2
Shield Tape BU
BU Holder
BU
Shortland Position
The components identified by
mark
mark
or dotted line with mark
are critical for safety.
Replace only with part number
specified.
specified.
Note:
Shield tape BU must be
replaced once it remove.
replaced once it remove.
Click on the first or last page to see other DVP-PR30 / DVP-PR50P / DVP-PR60P service manuals if exist.