Read Sony DVP-PQ1 Service Manual online
– 4 –
SERVICE NOTE
1.
DISASSEMBLY
• This set can be disassembled in the order shown below.
Set
Lid Assembly
(Page 2-1)
BU Holder
(Page 2-1)
SW-370 Board
(Page 2-2)
Disk Base Assembly
(Page 2-1)
Base Unit
(Page 2-1)
Jack Plate
(Page 2-2)
Lower Case
(Page 2-2)
AV-65 Board
(Page 2-3)
IF-95 Board
(Page 2-3)
MB-103 Board
(Page 2-3)
Shield Plate
(Page 2-3)
Power Switching
Regulator Block
(Page 2-2)
2.
PRECAUTIONS FOR USE OF BASE UNIT
As the laser diode in the base unit is easily damaged by static
electricity, desolder the laser tap of the flexible board of the base
unit when using it.
Before disconnecting the connector, solder first. Before connect-
ing the connector, be careful not to remove the solder. Also take
adequate measures to prevent damage by static electricity. Handle
the flexible board with care as it breaks easily.
electricity, desolder the laser tap of the flexible board of the base
unit when using it.
Before disconnecting the connector, solder first. Before connect-
ing the connector, be careful not to remove the solder. Also take
adequate measures to prevent damage by static electricity. Handle
the flexible board with care as it breaks easily.
Base unit
Laser tap
Click on the first or last page to see other DVP-PQ1 service manuals if exist.