Read Sony DVP-NS9100ES Service Manual online
6
DVP-NS9100ES
HOW TO OPEN THE LOADING PANEL WHEN POWER SWITCH TURNS OFF
POWER2 BOARD SERVICE POSITION
loading panel
tapering driver
cam (66)
1
Insert a tapering driver (3 mm in diameter)
in the hole at the bottom of the unit,
turn the cam (66) fully in the direction of arrow
in the hole at the bottom of the unit,
turn the cam (66) fully in the direction of arrow
A
.
2
Draw out the loading panel
in the direction of arrow
in the direction of arrow
B
.
A
B
POWER1 board
POWER2 board
mechanism deck
Note1: When remove the loading panel.
(Refer to page 13, 3-3. FRONT PANEL SECTION.)
Note2: When checking the POWER2 board on the lower side,
remove the POWER1 board and the POWER2 board,
and then reassemble the POWER1 board only to set
it in the service position.
In such a case, shift the mechanism deck in the arrow direction.
and then reassemble the POWER1 board only to set
it in the service position.
In such a case, shift the mechanism deck in the arrow direction.
Click on the first or last page to see other DVP-NS9100ES service manuals if exist.