DVP-NS9100ES - Sony DVD Service Manual (repair manual). Page 15

15

This mode let you lock the disc tray. When this mode is activated,
the disc will not eject when

A

button is pressed. The message

“TRAY LOCKED” will be displayed in on the FL tube.

1. Press the

I/

1

button to turn the power on.

2. While pressing the

x

button, press the

A

button until “TRAY

LOCKED” or “TRAY UNLOCKED” displayed on the FL tube
(around 5 seconds).

This player can lock the disc tray to prevent children from opening
it.

1. In the standby mode, press the [RETURN], [ENTER],

I/

1

buttons

on the remote in this order.

2. It turns on and “LOCKED” appears on the FL tube.
3. The [OPEN/CLOSE] button on the player and the remote do

not work while this lock is set.

4. To  release this lock, when the player is in standby mode,

operate the remote in the same manner as step 1 again.
It turns on and “UNLOCKED” appears on the FL tube.

If the supplied remote interferes with your other Sony DVD player,
change the command mode setting for this player and the supplied
remote to one that differs from the other Sony DVD player.
The default command mode setting for this player and the supplied
remote is DVD 1.

1. Slide the COMMAND MODE switch in the battery case of

the remote to select the command mode (DVD 1, DVD 2, or
DVD 3) so that the setting for the remote differs from that of
the other DVD players.
For example, if the other DVD players respond to the default
command mode setting for the supplied remote (DVD 1), set
the remote to DVD 2 or DVD 3.

2. In the standby mode, hold down [MULTI/2CH]  button and

press

I/

1

button on the player. The command mode appears

on the FL tube as follows.

3. Repeat steps 2 and 3 until the displayed command mode

matches that of the supplied remote.

If this mode is executed, each setting data is initialized.

1. In the standby mode, while pressing the

X

and [SA-CD/CD]

buttons, press the

N

button.

2. When enter the Ship Mode, it displays “SETUP INIT” on the

FL tube and start the data initializing.

3. When the initializing is complete, it displays “FINISHED”

on the FL tube. Then press the

I/

1

button and back to standby

mode.

Sample display

C, MODE DVD2