DVP-NS777P - Sony DVD Service Manual (repair manual). Page 67

Mode

E-E

Instrument

Digital voltmeter

EVER +5 V Check

Test point

CN201 pin 4

Specification

5.0 

± 0.3 Vdc

SW +3.3 V Check

Test point

CN201 pin 5

Specification

3.3 

± 0.2 Vdc

SW +5 V Check

Test point

CN201 pin 6

Specification

5.0 

± 0.3 Vdc

SW +8 V Check

Test point

CN201 pin 1

Specification

8.0 

± 1.0 Vdc

EVER +11 V Check

Test point

CN201 pin 3

Specification

11.2 

± 1.0 Vdc

EVER –10 V Check

Test point

CN201 pin 0

Specification

–10.0 

± 1.0 Vdc

Checking method:
1) Confirm that each voltage satisfies the specification.

Because the heatsink installed on the power supply board is a
part of the primary side, never touch it to avoid electrical shock.

During diagnostic check, the characters and color bars can
be seen only with the NTSC monitor. Therefore, for diag-
nostic check, use the monitor that supports both NTSC and
PAL modes.
Use the reference disc for PAL for check, and use the refer-
ence disc for NTSC for adjustment.

This section describes procedures and instructions necessary for
adjusting electrical circuits in this set.

1) Color monitor TV
2) Oscilloscope 1 or 2 phenomena, band width over 100 MHz,

with delay mode

3) Frequency counter (over 8 digits)
4) Digital voltmeter
5) Standard commander (RMT-D166P)
6) DVD reference disc

HLX-501 (J-6090-071-A) (dual layer) (NTSC)
HLX-503 (J-6090-069-A) (single layer) (NTSC)
HLX-504 (J-6090-088-A) (single layer) (NTSC)
HLX-505 (J-6090-089-A) (dual layer) (NTSC)
HLX-506 (J-6090-077-A) (single layer) (PAL)
HLX-507 (J-6090-078-A)(dual layer) (PAL)

7) SACD reference disc

HLXA-509 (J-6090-090-A)

8) Extention Cable (J-6090-107-A)