Read Sony DVP-NC650V Service Manual online
– 6 –
6) Mount the lock lever (See Fig. 5.)
7) Mount the spring (lock lever). (See Fig. 5.)
7) Mount the spring (lock lever). (See Fig. 5.)
8) Rotate the gear (main) in the direction of arrow A by 90
°
turn. (Gear (U/D) is up position.) (See Fig. 6.)
9) Mount the Gear (rev). (See Fig. 6.)
10) Fix three stopper washers on the groove of shafts.
10) Fix three stopper washers on the groove of shafts.
(See Fig. 6.)
Fig. 5
Fig. 6
Spring
(lock lever)
(lock lever)
Spring
(lock lever)
(lock lever)
Lock lever
Lock lever
Gear
(main)
(main)
Shaft
Stopper washer
Gear (rev)
Gear (main)
Gear (U/D)
Two stopper
washers
washers
Groove
*
*
*
A
5.
HOW TO SERVICE MB-101 BOARD
• Use the service jig (J-6090-107-A).
1) Remove the upper case from the set. (Refer to 2-1)
2) Remove the reinforcement (C) block. (Refer to 2-2)
3) Remove the front panel section. (Refer to 2-3)
4) Remove the rear panel block as shown in Fig. 7.
1) Remove the upper case from the set. (Refer to 2-1)
2) Remove the reinforcement (C) block. (Refer to 2-2)
3) Remove the front panel section. (Refer to 2-3)
4) Remove the rear panel block as shown in Fig. 7.
Fig. 8
3
Claw
2
Claw
4
Rear panel block
1
Screw (B3)
1
Four screws (B3)
2
Bracket (CP)
3
Three step
screws
screws
5
Two flexible flat cables
(FOM-001, FMM-040)
(FOM-001, FMM-040)
4
Optical pick-up
block
block
Fig. 7
5) Remove the MB-101 board. (Refer to 2-6)
6) Remove two flexible flat cables as shown in Fig. 8.
6) Remove two flexible flat cables as shown in Fig. 8.
Click on the first or last page to see other DVP-NC650V service manuals if exist.