Read Sony DVP-NC600 Service Manual online
– 6 –
6) Mount the lock lever (See Fig. 5.)
7) Mount the spring (lock lever). (See Fig. 5.)
7) Mount the spring (lock lever). (See Fig. 5.)
8) Rotate the gear (main) in the direction of arrow A by 90
°
turn. (Gear (U/D) is up position.) (See Fig. 6.)
9) Mount the Gear (rev). (See Fig. 6.)
10) Fix three stopper washers on the groove of shafts.
10) Fix three stopper washers on the groove of shafts.
(See Fig. 6.)
Fig. 5
Fig. 6
Spring
(lock lever)
(lock lever)
Spring
(lock lever)
(lock lever)
Lock lever
Lock lever
Gear
(main)
(main)
Shaft
Stopper washer
Gear (rev)
Gear (main)
Gear (U/D)
Two stopper
washers
washers
Groove
*
*
*
A
5.
HOW TO SERVICE MB-98 BOARD
• Jig (J-6090-107-A) Extension cable
• Jig (J-6090-108-A) Extension cable
• Jig (J-6090-108-A) Extension cable
CK-105 board
Stand
(with CK-106 Board)
(with CK-106 Board)
Eight flexible flat cables
FFC 5P (EXCEPT DVP-NC600), FFC 9P,
FFC 15P, FFC26 P,
FFC 9P (DVP-NS500P/NS700P),
FFC 15P (DVP-NS400D),
FFC 25P
(EXCEPT DVP-NS300 J model/NC600),
FFC 29P (DVP-NS300 J model)
FFC 15P, FFC26 P,
FFC 9P (DVP-NS500P/NS700P),
FFC 15P (DVP-NS400D),
FFC 25P
(EXCEPT DVP-NS300 J model/NC600),
FFC 29P (DVP-NS300 J model)
Two flexible flat cables
FFC 11P, FFC 25P
1) Remove the upper case and reinforcement (C) from the set.
(Refer to 2-1)
2) Remove the rear panel. (Refer to 2-1)
3) Remove the MB-98 board. (Refer to 2-1)
4) Set the stand (with CK-106 board) as shown in Fig. 7.
3) Remove the MB-98 board. (Refer to 2-1)
4) Set the stand (with CK-106 board) as shown in Fig. 7.
Fig. 7
1
MB-98 board
2
Stand
(with CK-106 board)
(with CK-106 board)
3
Connector (CN101)
4
Two screws (B3)
Click on the first or last page to see other DVP-NC600 service manuals if exist.