Read Sony DVP-FX810 / DVP-FX810BP (serv.man2) Service Manual online
8-1
SECTION 8
ELECTRICAL ADJUSTMENT
DVP-FX810/FX810BP
This section describes procedures and instructions necessary for
adjusting electrical circuits in this set.
adjusting electrical circuits in this set.
Instruments required:
1) Color monitor TV
2) Oscilloscope 1 or 2 phenomena, band width over 100 MHz,
2) Oscilloscope 1 or 2 phenomena, band width over 100 MHz,
with delay mode
3) Frequency counter (over 8 digits)
4) Digital voltmeter
5) Standard commander (RMT-D182A)
6) DVD reference disc
4) Digital voltmeter
5) Standard commander (RMT-D182A)
6) DVD reference disc
HLX-501 (J-6090-071-A) (dual layer) (NTSC)
HLX-503 (J-6090-069-A) (single layer) (NTSC)
HLX-504 (J-6090-088-A) (single layer) (NTSC)
HLX-505 (J-6090-089-A) (dual layer) (NTSC)
HLX-503 (J-6090-069-A) (single layer) (NTSC)
HLX-504 (J-6090-088-A) (single layer) (NTSC)
HLX-505 (J-6090-089-A) (dual layer) (NTSC)
8-1. STANDARD VIDEO LEVEL
1. Checking Video Output Level
<Purpose>
This checks whether Video Output level satisfy the NTSC stan-
dard. If it is not correct, the brightness will be too large or small.
This checks whether Video Output level satisfy the NTSC stan-
dard. If it is not correct, the brightness will be too large or small.
Mode
Play
Signal
Check the Color-bar (100%) signal
on DVD reference disc
on DVD reference disc
Measurement Point
LINE OUT (VIDEO) connector
(75
(75
Ω
terminated)
Measuring Instrument
Oscilloscope
Specification
1.00
±
0.02 Vp-p
Checking method:
1) Confirm that the Video Output level is 1.00
1) Confirm that the Video Output level is 1.00
±
0.02 Vp-p.
Figure 8-1
1.00
±
0.02 Vp-p
Click on the first or last page to see other DVP-FX810 / DVP-FX810BP (serv.man2) service manuals if exist.