Read Sony DVP-F5 / DVP-FX1 Service Manual online
— 6 —
SERVICE NOTES
1. REPLACING OPTICAL PICK-UP
1-1.
Handling
1)
A red laser diode for DVD requires more attention to static
electricity than general infrared laser diodes for CD.
Because its durability to static electricity is far weaker than
that of infrared laser diodes, always use an earth band when
handling the optical pick-up block as service parts.
electricity than general infrared laser diodes for CD.
Because its durability to static electricity is far weaker than
that of infrared laser diodes, always use an earth band when
handling the optical pick-up block as service parts.
2)
The optical pick-up of the DVP-F5/FX1 cannot be replaced as
a single part. It is supplied as the MD COMPLE (DVDM-
FX1).
a single part. It is supplied as the MD COMPLE (DVDM-
FX1).
Note: When the MD COMPLE is going to be replaced, be very
careful not to damage the flexible board to peel off the
flexible board because the flexible board is attached
underneath the cabinet by the double-sided adhesive tape.
flexible board because the flexible board is attached
underneath the cabinet by the double-sided adhesive tape.
3)
When handling the MD COMPLE (DVDM-FX1), be careful
not to touch the portions specified in the illustration of the MD
COMPLE with hand. Be sure to hold the hatched portions
described as “HOLD” in the illustration.
not to touch the portions specified in the illustration of the MD
COMPLE with hand. Be sure to hold the hatched portions
described as “HOLD” in the illustration.
1-2.
Connection of the DM flexible extension
board (J-6090-101-A) for service
board (J-6090-101-A) for service
For any attempt is going to be made to inspect, check and adjust
the MB-90 board, connect the DM flexible extension board as
shown below.
the MB-90 board, connect the DM flexible extension board as
shown below.
MD COMPLE
( DVDM-FX1)
( DVDM-FX1)
SLED-CN
OP-CN
SPDL-CN
7-pin fle
xib
le board (194mm)
18-pin fle
xib
le
board
(114mm)
10-pin fle
xible board
(114mm)
MB-90 board
CN802 (16 pin)
CN801 (18 pin)
CN804 (10 pin)
CN803
(7 pin)
(7 pin)
16-pin fle
xib
le board (114mm)
Hold
position
position
Hold position
Hold position
Lens actuator
covers
covers
Double-sided
adhesive tape
adhesive tape
From
spindle motor
spindle motor
From optical
block pick-up
block pick-up
Objective lens
Turntable
(spindle motor)
(spindle motor)
From
sled motor
sled motor
Flexible board
Click on the first or last page to see other DVP-F5 / DVP-FX1 service manuals if exist.