DVP-CX985V - Sony DVD Service Manual (repair manual). Page 6

6

The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.

The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.

When replacing the MB board, since the adjustment value is not
set up correctly, “Drive Auto Adjustment” can’t be performed.
In this case, initialize Memory in the following procedures.

Procedure:
1. Set the test mode. (See page 23)
2. Press the [2] key of the remote commander, and set the “DRIVE

MANUAL OPERATION”. (See page 29)

3. Press the [6] key of the remote commander, and set the “2-6,

Memory Check”. (See page 32)

4. Press the [CLEAR] key of the remote commander, and initial-

ize Memory.

Procedure:
1. Press the

I

/1

button to turn the power on.

2. Press two buttons of

x

and [OPEN/CLOSE] on the main unit

for 5 seconds or more.

The setting method and the releasing method are the same operation.

It is possible to analyze the defect with only POWER board power
ON.
Procedure:
1. Set to power OFF state.
2. Remove the connector from CN201 on the POWER board.
3. Short between CN201 pin 1 (P-CONT) and CN201 pin qa

(EVER+3.3V) on the POWER board.

4. Turn the power ON.
5. Confirm that the voltage value of CN201 each pin on the

POWER board satisfy following value .

CN201 Pin

Voltage Value

pin 2 (EVER–11V)

–11V

pin 3 (SW–11V)

–11V

pin 6, 7 (SW+11V)

+11V

pin 8 (SW+3.3V)

+3.3V

pin qa (EVER+3.3V)

+3.3V

pin qs (SW+5V)

+5V

pin qd (EVER+11V)

+11V