Read Sony DVP-C660 / DVP-C670D / DVP-C675D Service Manual online
– 6 –
6) Mount the lock lever (See Fig. 5.)
7) Mount the spring (lock lever). (See Fig. 5.)
7) Mount the spring (lock lever). (See Fig. 5.)
8) Rotate the gear (main) in the direction of arrow A by 90
°
turn. (Gear (U/D) is up position.) (See Fig. 6.)
9) Mount the Gear (rev). (See Fig. 6.)
10) Fix three stopper washers on the groove of shafts.
10) Fix three stopper washers on the groove of shafts.
(See Fig. 6.)
Fig. 5
Fig. 6
Spring
(lock lever)
(lock lever)
Spring
(lock lever)
(lock lever)
Lock lever
Lock lever
Gear
(main)
(main)
Shaft
Stopper washer
Gear (rev)
Gear (main)
Gear (U/D)
Two stopper
washers
washers
Groove
*
*
*
A
5
HOW TO SERVICE MB-87 BOARD
1) Remove the upper case from the set. (Refer to 2-1)
2) Remove the tray cover ass’y. (Refer to 2-2)
3) Remove the front panel section. (Refer to 2-3)
4) Remove the table ass’y. (Refer to 2-5)
5) Remove the MB-87 board. (Refer to 2-7)
6) Remove the BU holder ass’y. (Refer to 2-11)
7) Set the jig (J-6090-102-A) as shown in Fig. 1.
2) Remove the tray cover ass’y. (Refer to 2-2)
3) Remove the front panel section. (Refer to 2-3)
4) Remove the table ass’y. (Refer to 2-5)
5) Remove the MB-87 board. (Refer to 2-7)
6) Remove the BU holder ass’y. (Refer to 2-11)
7) Set the jig (J-6090-102-A) as shown in Fig. 1.
Fig. 1
8) Set the CH-jig1 board as shown in Fig. 2.
Fig. 2
9) Set the MB-87 board as shown Fig. 3.
CH-jig2 board
CN204
CN203
CN
104
CN
103
Two flexible flat cables
CH-jig1 board
2
CH-jig1 board
1
Two connectors
(CN101, 102)
(CN101, 102)
2
CH-jig2 board
1
3
Two
connectors
(CN201, 202)
connectors
(CN201, 202)
4
Two flexible flat
cables
(CN404, 405)
cables
(CN404, 405)
6
MB-87 board
5
BU holder
ass’y
ass’y
Fig. 3
Click on the first or last page to see other DVP-C660 / DVP-C670D / DVP-C675D service manuals if exist.