DAV-DZ10, HCD-DZ10 - Sony DVD Service Manual (repair manual). Page 21

21

In order to execute mirror time adjustment, the following standard
procedures must be followed.

(1) In power on, while pressing the  

x  

and  A  buttons

simultaneously, turn  VOLUME +  .

(2) Select “2. Drive Manual Operation” by pressing the  2 “R”

button on the remote commander. The screen will appear as
below.

(3) Select “3. Manual Adjustment” by pressing the  3 “R”  button

on the remote commander. The screen will appear as below.

(4) Select Iop by pressing the  6 “R”  button on the remote

commander.

Remocon Diagnosis Menu

0. External Chip Check
1. Servo Parameter Check
2. Drive Manual Operation
3. Emergency History Check
4. Version information
5. Video Level Adjustment

Model Name
IF-con  

: Ver. XX.XX (XXXX)

Syscon  

: Ver. X.XXX

: DSX0_ XX

*

1

*1: Changes depending on destination 

Drive Manual Operation

1. Servo Control
2. Track/Layer Jump
3. Manual Adjustment
4. Tray Aging Mode
5. MIRR time adjust
0. Return to top Menu

Manual Adjust

1. Track Balance Adjust:
2. Track Gain Adjust:
3. Focus Balance Adjust:
4. Focus Gain Adjust:
5. Eq boost Adjust:
6. Iop:
7. TRV. Level:
8. S curve(FE) Level:
9. RFL(PI) Level:
0. MIRR Time:

o

  O    Change Value

[RETURN] Return to previous menu

(5) Wait until a hexadecimal number appear.

(6) Convert each data from hexadecimal to decimal using
      conversion table.

(7) Substruct between these two values.

(8) If the remainder is smaller than 93 (decimal), then it is

OK. However if the value is higher than 93, then the BU is
defective and need to be change.

(9) Press the  RETURN “R”  button to return back to previous

menu.

(10) Press the  0 “R”  button to return to Top Menu and power

   OFF the DVD Player.

Manual Adjust

1. Track Balance Adjust:
2. Track Gain Adjust:
3. Focus Balance Adjust:
4. Focus Gain Adjust:
5. Eq Boost Adjust:
6. Iop. 53:
7. TRV. Level:
8. S curve(FE) Level:
9. RFL(PI) Level:
0. MIRR Time:

Change Value

[0] Return to previous menu

o

  O