DAV-DZ10, HCD-DZ10 - Sony DVD Service Manual (repair manual). Page 2

Read Sony DAV-DZ10 / HCD-DZ10 Service Manual online

2
HCD-DZ10
SAFETY-RELATED  COMPONENT  WARNING!!
COMPONENTS  IDENTIFIED  BY  MARK  
0
  OR  DOTTED  LINE
WITH  MARK  
0
  ON  THE  SCHEMATIC  DIAGRAMS  AND  IN
THE  PARTS  LIST  ARE  CRITICAL  TO  SAFE  OPERATION.
REPLACE  THESE  COMPONENTS  WITH  SONY  PARTS  WHOSE
PART  NUMBERS  APPEAR  AS  SHOWN  IN  THIS  MANUAL  OR
IN  SUPPLEMENTS  PUBLISHED  BY  SONY.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 
°C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 °C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
This appliance is classified as
a CLASS 1 LASER product.
This marking is located on the
rear of the unit.
MODEL IDENTIFICATION
– Rear Panel –
Model
Part No.
AEP, UK models
2-681-511-0
[]
RU model
2-681-511-1
[]
E12 model
2-681-511-2
[]
• Abbreviation
E12 : 220 – 240 V AC area in E model
RU : Russian model
Parts No.
General
Power requirements
220 – 240 V AC, 50/60 Hz
Power consumption
On: 95 W
Standby: 0.3 W (at the 
Power Saving mode) 
Dimensions (approx.)
430 
× 70 × 295 mm (w/h/d) 
incl. projecting parts
Mass (approx.)
3.6 kg
Design and specifications are subject to change 
without notice.
Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
Ver. 1.1
Page of 76
Display

Click on the first or last page to see other DAV-DZ10 / HCD-DZ10 service manuals if exist.