Read Sony DAV-DS1000 / SA-IR1000 Service Manual online
2
SA-IR1000
[AMP Board Input Signal Check Procedure]
Note 1:
Connect the SA-WS1000 to the DVX-DS1000. Set up the system so that the infrared signal from the front speaker (SS-IF1000) can
be received by the rear speaker (SA-IR1000).
Note 2:
The POWER LED of this unit (SA-IR1000) lights in red when the power of the SA-WS1000 is turned off (when data is not
transmitted.)
When the power of the SA-WS1000 is turned on and the infrared signal from the front speaker (SS-IF1000) is received by this unit
(SA-IR1000), the POWER LED of this unit (SA-IR1000) lights in green.
When the power of the SA-WS1000 is turned on and the infrared signal from the front speaker (SS-IF1000) is received by this unit
(SA-IR1000), the POWER LED of this unit (SA-IR1000) lights in green.
Check procedure:
1. Connect a spectrum analyzer and an oscilloscope to the connector CN110 pin-2 of F/E board.
1. Connect a spectrum analyzer and an oscilloscope to the connector CN110 pin-2 of F/E board.
PD
board
board
F/E
board
board
CN110 2 pin
Infrared
Transmission
Transmission
Front speaker
(SS-IF1000)
(SS-IF1000)
Spectrum analyzer
or Oscilloscope
or Oscilloscope
2. Confirm that the spectrum is displayed as shown in Fig. 1 on spectrum analyzer. Also confirm that the waveform as shown in Fig. 2
is displayed.
4.5MHz
↓
Fig. 1
Fig. 2
Click on the first or last page to see other DAV-DS1000 / SA-IR1000 service manuals if exist.