Read Sony BDP-CX7000ES Service Manual online
BDP-CX7000ES
5
ALIGNMENT OF GEAR (CAM) PHASE WITH DOOR ASSY
MB-124-MEGA-EJ AND VP-062EJ BOARDS SERVICE POSITION
• It is necessary to connect MB-124-MEGA-EJ board (CN904) and IMD (ES) board (CN3005) with the extension cable to do the setting
• It is necessary to connect MB-124-MEGA-EJ board (CN904) and IMD (ES) board (CN3005) with the extension cable to do the setting
to this position.
Prepare the following extension cables.
Part No. J-2501-068-A (19 pin, 1.00 mm pitch)
MB-124-MEGA-EJ board
VP-062EJ board
insulation
Connect jig (extension cable)
to the IMD board (CN3005)
to the IMD board (CN3005)
CN904
CAPACITOR ELECTRICAL DISCHARGE PROCESSING
When checking the board, for the electric shock prevention, con-
nect the resistors to both ends of respective capacitor (C106) to
discharge the capacitor (C106).
When checking the board, for the electric shock prevention, con-
nect the resistors to both ends of respective capacitor (C106) to
discharge the capacitor (C106).
HARNESS SETTING ON SWITCHING REGULATOR
Note: This illustration sees the switching regulator from component side.
door assy
gear (cam)
Align a slit of door assy with a marking on
the bottom land of gear tooth when the gear
is rotated fully in arrow direction, as shown.
the bottom land of gear tooth when the gear
is rotated fully in arrow direction, as shown.
C106
800
:/2 W
– Switching Regulator (Conductor Side) –
clamp (L35)
AC inlet (2P) harness
harness
wire
switching
regulator
regulator
Click on the first or last page to see other BDP-CX7000ES service manuals if exist.