Read Sony SAL85F14Z Service Manual online
HELP
SAL85F14Z (Planar 1.4/85) (Planar T
*
85mm F1.4 ZA)
Fixed Holding Tube Block
Install so that the burr side is upwards.
Friction Spring A
Torque Ring
Apply the adhesive bond (B-10)
(Two places to the screwed portion in the width 10 to 20mm)
(Two places to the screwed portion in the width 10 to 20mm)
Torque Ring Retainer
Focus Operation Ring
Friction Sheet
Friction Sheet
Groove
3 to 4 mm
3 to 4 mm
Groove
HELP26
Affix the friction sheet to three indicated portions of focus operation ring.
Note:
Affix the friction sheet so that the interval between the end of friction sheet and the focus operation ring is as shown in figure
below.
HELP27
Adhesive bond (B-10): J-6082-612-A
1.
Build in the friction spring A with the blurred surface place at the fixed holding tube block side.
2.
Build in the torque ring retainer to the fixed holding tube.
3.
Apply the adhesive bond (B-10) to the inner side screwed portion of torque ring holder in the width of 10 to 20mm.
4.
Tighten the torque ring holder to the fixed barrel block with the lens special fixture.
Click on the first or last page to see other SAL85F14Z service manuals if exist.