SAL70200G2 - Sony Digital Camera Service Manual (repair manual). Page 11

2-8

SAL70200G2 (2.8/70-200 G SSM Ⅱ) (70-200mm F2.8 G SSM II)

Adhesive bond (B-10): J-6082-612-A

1.  Fix the CL-032 board with three fixing screws. Apply the adhesive bond (B-10) to the heads of screws. (Three locations)
2.  Solder two lead wires (black/red) leading from the flexible BL PWB and three lead wires (blue/black/yellow) leading from the stator.

CL-032 Board

(Side A)

CL-032 Board

Apply the adhesive bond (B-10)

Apply the adhesive bond (B-10)

(From Flexible 
BL PWB)

Harness (Red)

Harness (Black)

Harness (Yellow)

(From Stator)

Harness (Blue)

Harness (Black)

Adhesive bond (B-10): J-6082-612-A

1.  Route the harness leading from the flexible BL PWB and the harness leading from the stator as shown in the figure.
2.  Fix the CL-034 board with three fixing screws.
3.  After tightening the screws, apply the adhesive bond (B-10) to the heads of screws.

Apply the adhesive bond (B-10)

CL-034 Board

Route the harness leading 
from the flexible BL PWB
as shown in the figure.

Route the harness 
leading from the stator 
as shown in the figure.

Adhesive bond (B-10): J-6082-612-A

1.  Route the harness leading from the flexible BL PWB.
2.  Install the CL-033 board and fix it with two screws.
3.  After tightening the screws, apply the adhesive bond (B-10) to the heads of screws.
4.  Solder the flexible BL PWB and zoom encoder flexible to the CL-033 board.

CL-033 Board

Solder the 
flexible BL PWB

Apply the adhesive bond (B-10)

Solder the zoom 
encoder flexible

Route the harness leading from the flexible BL PWB 
as shown in the figure