Read Sony SAL70200G (serv.man2) Service Manual online
HELP
SAL70200G (2.8/70-200 G) (70-200mm F2.8 G)
HELP25
Adhesive bond (B-10):
J-6082-612-A
Adhesive bond (LOCTITE 460)
Note:
Use the adhesive bond (LOCTITE 460) or the equivalent.
Do not use the instant glue that becomes white when dried.
1.
Set the flexible substrate setting tape, FH flexible PC board and click plate to the front holding tube and fix them with washers and
screws.
2.
Apply the adhesive bond (B-10) to the location indicated in the figure.
Note:
If too much adhesive bond is applied, it flows in the gap in the click plate and FH flexible PC board and causes no conduction.
3.
Affix the FHB shielding tape as shown in the figure.
4.
Apply the adhesive bond (LOCTITE 460) to the indicated portion of front holding tube.
5.
Install the focus hold button and the focus hold button base and fix them with a scotch tape until the adhesive bond dries.
Flexible Substrate Setting Tape
FH Flexible PC Board
Front Holding
Tube
Tube
Click Plate
Click Plate
Screw
Washer
Washer
Affix the
FHB shielding tape
FHB shielding tape
Apply the
adhesive bond
(LOCTITE 460)
adhesive bond
(LOCTITE 460)
Focus Hold
Button Base
Button Base
Focus Hold Button,
Focus Hold Button Base
Focus Hold Button Base
Focus Hold
Button
Button
Scotch tape,
etc.
etc.
Scotch tape,
etc.
etc.
Apply the
adhesive bond
(B-10)
adhesive bond
(B-10)
Click on the first or last page to see other SAL70200G (serv.man2) service manuals if exist.