Read Sony SAL24F20Z Service Manual online
2-6
SAL24F20Z (Distagon 2/24 ZA T * SSM) (Distagon T * 24mm F2 ZA SSM)
HELP08
Grease (G-35) : J-6082-621-A
1. Apply the grease (G-35) to the back side of the rotor base, install the rotor base.
2. Install the stator (ultrasonic motor) and the rotor (ultrasonic motor).
2. Install the stator (ultrasonic motor) and the rotor (ultrasonic motor).
Note 1:
Never touch the slip surface of stator (ultrasonic motor) and resin surface of rotor (ultrasonic motor) (black coated surface).
Note 2:
Align the flexible board of the stator (ultrasonic motor) with the DV flexible PWB so that they come on the diagonal line.
3. Install the nylon sheet, resin ring (ultrasonic motor), fine same (ultrasonic motor), plate (pressure plate), wave washer (ultrasonic motor),
motor holding washer in the correct order.
Note 3:
Install the wave washer (ultrasonic motor), facing its concave side down and its convex side up.
Note 4:
Install the pressure plate, facing the curved side to the sheet.
Apply the grease (G-35)
Curved side
Note 4:
Note 2:
Note 3:
Curved side
Burr side
Motor Holding Washer
Rotor
(Ultrasonic Motor)
(Ultrasonic Motor)
Stator
(Ultrasonic Motor)
(Ultrasonic Motor)
Resin Ring
(Ultrasonic Motor)
(Ultrasonic Motor)
Plate
(Pressure Plate)
(Pressure Plate)
Rotor Rubber
Rotor Base
Rotor Base
(Backside)
Fine Same
(Ultrasonic Motor)
(Ultrasonic Motor)
Nylon Sheet
Wave Washer
(Ultrasonic Motor)
(Ultrasonic Motor)
Flexible board of
the stator
(ultrasonic motor)
the stator
(ultrasonic motor)
DV flexible PWB
Cross section
Cross section
Cross section
Note 1:
Never touch the slip surface of stator
(ultrasonic motor) and resin surface of
otor (ultrasonic motor) (black coated
surface).
(ultrasonic motor) and resin surface of
otor (ultrasonic motor) (black coated
surface).
HELP09
Grease (FT-210) : 7-640-018-91
Grease (G-35) : J-6082-621-A
Grease (G-35) : J-6082-621-A
1. Apply the grease (G-35) to indicated locations of the middle barrel.
Apply the grease (G-35)
Cross section
Middle Barrel
2. Apply the grease (FT-210) to the focus joint ring sliding surface of the slide washer, and install the slide washer.
3. Apply the grease (G-35) to the differential ring assy block sliding surface of the focus joint ring, and install the focus joint ring.
3. Apply the grease (G-35) to the differential ring assy block sliding surface of the focus joint ring, and install the focus joint ring.
Apply the grease (G-35)
Apply the grease (FT-210)
Differential ring assy block sliding surface
Focus joint ring sliding surface
Focus Joint Ring
Slide Washer
Click on the first or last page to see other SAL24F20Z service manuals if exist.