Read Sony SAL2470Z2 Service Manual online
4-15
SAL2470Z2 (Vario-Sonnar 2.8/24-70 ZA SSM II) (Vario-Sonnar T* 24-70mm F2.8 ZA SSM II)
4) In case that OK does not appear on both the Amp and Mean columns in all ranges while rotating the focus in the MR wave check,
adjust by moving the position of the MR sensor.
5) After adjustment, apply the adhesive bond (B-10) to the head of screw.
MR Block Assy
Apply the adhesive
bond (B-10).
bond (B-10).
Adjustment procedure: Loosen two screws and adjust by moving
the position of the MR sensor (MR Block Assy)
the position of the MR sensor (MR Block Assy)
Fig.
4-8-6
4-9. FOCUS BRUSH POSITION CHECK/ADJUSTMENT
Equipment
• Personal Computer
• Finished Inspection JIG II (AC 100 V only)
• Lens Adjustment Program (ACSSM-S-VerXXX.zip)
• Adhesive bond (B-10)
• Half Completion JIG
• Personal Computer
• Finished Inspection JIG II (AC 100 V only)
• Lens Adjustment Program (ACSSM-S-VerXXX.zip)
• Adhesive bond (B-10)
• Half Completion JIG
Note:
Please make the Half Completion JIG in each service station.
For details of the jig making method, refer to 4-1-1. List of Service Tools and Equipment Note 6.
1. Preparations
1) Set the checking lens to the condition as shown in Fig. 4-9-1 (Half completion).
1) Set the checking lens to the condition as shown in Fig. 4-9-1 (Half completion).
Brush
Screw
Fig.
4-9-1
2) Connected to equipment with checking lens. (Refer to 4-1-4. Connection of Finished Inspection JIG II/Half Completion JIG and
Startup of Lens Adjustment Program (ACSSM-S-VerXXX) )
3) Start up the lens adjustment program (ACSSM-S-VerXXX.exe).
4) Click [Set up], and perform the initial setting. (Refer to 4-1-5. Initial Setting of Lens Adjustment Program (ACSSM-S-VerXXX) )
4) Click [Set up], and perform the initial setting. (Refer to 4-1-5. Initial Setting of Lens Adjustment Program (ACSSM-S-VerXXX) )
2. Adjusting Method
1) Set the focus to infinity position and the zoom to WIDE position in Fig. 4-9-2.
2) Loosen a little the screw fixing the brush.
1) Set the focus to infinity position and the zoom to WIDE position in Fig. 4-9-2.
2) Loosen a little the screw fixing the brush.
Set the focus to infinity position
Loosen a little the screw
Brush
Fig.
4-9-2
3) Click the [Adjust Focus Brush].
Fig.
4-9-3
4) In case of the focus is at the focus adjustment point, the pop-up window as shown below appears on the screen, tighten the screw at the
point.
Fig.
4-9-4
Click on the first or last page to see other SAL2470Z2 service manuals if exist.