Read Sony SAL1680Z Service Manual online
4-40
SAL1680Z (Vario-Sonnar DT 3.5-4.5/16-80 ZA) (Vario-Sonnar T
*
DT 16-80mm F3.5-4.5 ZA)
4)
When the tele position check finishes normally, the message “Move ZOOM to WIDE position at about 10sec.” is displayed on the
pop-up window.
Set the zoom to the wide position and press down the ENTER key.
Fig.4-10-19
5)
When the wide position check finishes normally, the message “Reverse ZOOM to TELE position at about 10sec.” is displayed on the
pop-up window.
Set the zoom to the tele position and press down the ENTER key.
Fig.4-10-20
6)
When the infinity position check finishes normally, “OK” is displayed on the pop-up window, and press the ENTER key to return to
the initial window.
Fig.4-10-21
3. In case of error display in the Zoom Pattern (Tele position (first try))
1)
When the error display and the NG display appear to the pop-up window, press the ENTER key to return to the initial window, and
perform “2. Checking Method”again.
Fig.4-10-22
Fig.4-10-23
2)
Although the lens is positioned at the tele position, if “NG” appears, confirm or perform the following.
• 4-10-1. Zoom Brush Position Adjustment (Search Zoom Adjustment Point)
• Cleaning of flexible pattern or the brush.
• Replaceing the brush.
• Rotating operation error of the focus ring (rotation speed is not suitable at a regulated speed.).
3)
Perform “2. Checking Method”again, repeat the inspection until “OK” appears on the pop-up window.
Click on the first or last page to see other SAL1680Z service manuals if exist.