NEX-5N, NEX-5ND, NEX-5NK, NEX-5NY (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 4

NEX-5N/5ND/5NK/5NY_L2

1-1

When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.

The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.

Perform the following procedures for each of the three washers.

Note: Measure the dimensions before replacement of the Cabinet Front according to procedures (1) to (3).

(1) Remove the Imager Block Assy and the IM Adjust Washers (A, B, C).

(2) Measure the dimensions (A) of the removed IM Adjust Washers.

A

+

B

BA

(3) Measure the distance (B) between the surface of the screw hole where the IM Adjust Washers were set and the surface of the E-Mount.
(4) Likewise, measure the dimensions (B’) of each location where IM Adjust Washers of new Cabinet Front are installed.
(5) Calculate the dimension of (A’) of new IM Adjust Washer by using the formula below, and select the washers.
  

Dimension 

(A+B) before replacement – Dimension (B’) of new Cabinet Front

           

= Dimension (A’) of IM Adjust Washer after replacement

(6) Assemble the imager, using the selected IM Adjust Washers.
(7) After assembling is completed, perform the test shooting and confirm that no blur is observed in the peripheral area of shot.

If you attach the flash directly to the camera when using SEL55210 (E 55-210mm F4.5-6.3 OSS), images will be partly shadowed by the lens.
To prevent shadowing, attach the extender.

Extender
A-1787-305-A

Case, EX
4-199-652-01

(1) Turn the camera off before attaching the extender.

(2) Attach the extender firmly to the camera and tighten the screw.

(3) Attach the flash firmly to the extender and tighten the screw.

Note: Only attach the flash supplied with your camera to the extender.