Read Sony NEX-3 / NEX-3A / NEX-3D / NEX-3K / NEX-5 / NEX-5A / NEX-5CK / NEX-5D / NEX-5H / NEX-5K (serv.man2) Service Manual online
NEX-3A/3D/3K/5A/5D/5CD/5K/5CK_L2
1-1
1. SERVICE NOTE
1-1. PRECAUTION ON REPLACING THE SY-258 BOARD
Destination Data
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
USB Serial No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
– ENGLISH –
1-2. PRECAUTION ON REPLACING THE CABINET FRONT
Perform the following procedures for each of the three washers.
Note: Measure the dimensions before replacement of the Cabinet Front according to procedures (1) to (3).
(1) Remove the Imager Block Assy and the IM Adjust Washers (A, B, C).
(2) Measure the dimensions (A) of the removed IM Adjust Washers.
A
A
+
B
B
(3) Measure the distance (B) between the surface of the screw hole where the IM Adjust Washers were set and the surface of the E-Mount.
(4) Replace Cabinet Front.
(5) Measure the distance after replacement of the Cabinet Front (B) between the surface of the screw hole where the IM Adjust Washers were set and
the surface of the E-Mount, then compare it with the distance before replacement (B).
•
If the distance after replacement (B) is shorter than that before replacement (B)
Add IM Adjust Washer with the thickness equal to the difference of dimensions to make the distance (B) equal to that before replacement.
•
If the distance after replacement (B) is longer than that before replacement (B)
Replace to the IM Adjust Washer with the thickness equal to the difference of dimensions
(distance before replacement (A+B) - distance after replacement (B)).
(6) After assembly, take a test shot to check if there is any blur at circumference of the image.
1-3. ABOUT THE FLASH EXTENDER (NEX-5H ONLY)
If you attach the flash directly to the camera when using SEL18200 (E 18-200mm F3.5-6.3 OSS), images will be partly shadowed by the lens.
To prevent shadowing, attach the extender.
Extender
A-1787-305-A
Case, EX
4-199-652-01
To attach the extender
(1) Turn the camera off before attaching the extender.
(2) Attach the extender firmly to the camera and tighten the screw.
(2) Attach the extender firmly to the camera and tighten the screw.
(3) Attach the flash firmly to the extender and tighten the screw.
Note: Only attach the flash supplied with your camera to the extender.
The changed portions from
Ver.1.2 are shown in blue.
Ver.1.3 2010.09
Click on the first or last page to see other NEX-3 / NEX-3A / NEX-3D / NEX-3K / NEX-5 / NEX-5A / NEX-5CK / NEX-5D / NEX-5H / NEX-5K (serv.man2) service manuals if exist.