Read Sony DSLR-A100 / DSLR-A100H / DSLR-A100K / DSLR-A100W (serv.man3) Service Manual online
6-15
DSLR-A100_ADJ
Fig. 3
Two bosses
Repair (when it cannot be adjusted by the above adjustment method)
1. Disassemble until the CCD Set can be removed.
2. Cut at two bosses for positional reference and directional reference of the CCD holder and the radiation plate. (Fig. 3)
3. Attach an insulation sheet to the terminal of CCD Set. (Prevention of short-circuit with CCD holder)
4. Assemble the CCD Set by shifting it by the amount of play
2. Cut at two bosses for positional reference and directional reference of the CCD holder and the radiation plate. (Fig. 3)
3. Attach an insulation sheet to the terminal of CCD Set. (Prevention of short-circuit with CCD holder)
4. Assemble the CCD Set by shifting it by the amount of play
If an image tilts toward the lower right, shift clockwise the CCD Set by the amount of play.
If an image tilts toward the lower left, shift counterclockwise the CCD Set by the amount of play.
The double-sided adhesive tape on the LPF, if shifted by the amount of play, can be corrected in a range of about +/–0.7 degree
maximum.
In this case, however, prepare the service part “Slider Unit: A-1246-028-C” and modify it as described in step 2 above to make it as a
jig, and then shift the LPF on the jig (for prevention of damage to the Steadyshot Set of user's camera).
If an image tilts toward the lower left, shift counterclockwise the CCD Set by the amount of play.
The double-sided adhesive tape on the LPF, if shifted by the amount of play, can be corrected in a range of about +/–0.7 degree
maximum.
In this case, however, prepare the service part “Slider Unit: A-1246-028-C” and modify it as described in step 2 above to make it as a
jig, and then shift the LPF on the jig (for prevention of damage to the Steadyshot Set of user's camera).
5. Assemble up to the exterior.
6. Check the tilt following the checking method.
6. Check the tilt following the checking method.
*If not within +/–0.5 degree, replace the “Slider Unit: A-1246-028-C” and recheck.
7. After the repair completed, perform “CCD Aori and Center Adjustment” and “Steadyshot Sensitivity Adjustment”.
Ver. 1.3 2007.10
Click on the first or last page to see other DSLR-A100 / DSLR-A100H / DSLR-A100K / DSLR-A100W (serv.man3) service manuals if exist.