Read Sony DSC-WX5 (serv.man2) Service Manual online
DSC-WX5/WX5C_L2
1-7
– ENGLISH –
1-7. ORNAMENTAL RING A OR BARRIER ASSY REPLACING METHOD
下図は当機種と本体の形状が異なります。
Note:
Note:
As for the figure below, this model and the shape
of the main body are different.
of the main body are different.
2
Peel off release papers of Barrier Tapes.
3
Install Ornamental Ring A and press it lightly.
Installation
1
1
With four claws fitted in position, install the Barrier Assy.
5
Remove Barrier Assy by disengaging four claws.
Barrier Assy
Removal
1
1
Turn on the power switch and extend the lens.
2
Detach the battery.
3
Pour a solvent such as alcohol from two places A to the tweezers or a needle shown below into a gap of Ornamental Ring A.
4
Remove while turning the Ornamental Ring A right and left.
Claws
Claws
Ornamental Ring A
A
Solvent
Tweezers
Barrier Assy
Barrier Tape
Barrier Tape
Barrier Assy
Barrier Lever
Hole
Claws
Claws
Ornamental Ring A
Barrier Tapes
1-8. ZOOM GEAR BLOCK REPLACING METHOD
Removal
1
1
Remove one screw.
2
Remove the Zoom Gear Block upward.
3
Remove the Naruto Gear.
4
Remove the Z Tape.
Note: The Z Tape is not supplied. Please reuse.
Note: The Z Tape is not supplied. Please reuse.
5
Disengage two claws A and B in this order to remove the FG Plate Spring.
Note: The FG Plate Spring cannot be reused.
Note: The FG Plate Spring cannot be reused.
6
Remove two sensors on the lens flexible board.
7
Break two solders, and remove the lens flexible board.
Installation
1
1
Confirm the direction of Zoom Gear Block, and install the lens flexible board with two solders.
2
Install two sensors of Zoom Gear Block.
3
Engage two claws A and B in this order to install FG Plate Spring.
4
Stick the Z Tape.
5
Install Naruto Gear (S).
6
With four bosses fitted in position, install Zoom Gear Block.
7
Tighten one screw.
*Tightening torque = 0.068 ± 0.01N • m (0.7 ± 0.1kg f • cm)
*Tightening torque = 0.068 ± 0.01N • m (0.7 ± 0.1kg f • cm)
Screw
Zoom Gear Block
Zoom Gear Block
FG Plate Spring
Z Tape
Sensors
Solders
Naruto Gear
Claw A
Claw B
Zoom Gear Block
FG Plate Spring
Z Tape
Sensors
Solders
Claw B
Claw A
Front Side
Rear Side
Screw
Zoom Gear Block
Naruto Gear
Bosses
Bosses
Click on the first or last page to see other DSC-WX5 (serv.man2) service manuals if exist.