DSC-W380 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 14

DSC-W380_L2

1-11

qk

Install the Rear Mirror Tube Assy on the Main Assy.
Note: Do not pinch the Flexible Board between the Rear Mirror Tube Assy and the Main Assy.

ql

Tighten up four screws in order of 

1 → 2 → 3 → 4.

* Tightening torque = 0.068 

± 0.01N • m (0.7 ± 0.1kgf • cm)

Rear Mirror Tube Assy

1

3

4

2

w;

Arrange the Flexible Board.

Main Assy

Rib

Rib

Boss

⎯ Left View ⎯

⎯ Bottom View ⎯

⎯ Top View ⎯

⎯ Right View ⎯

⎯ Rear View ⎯

Boss

Boss

Boss

Boss

Adhesive Sheet

Adhesive Sheet

Boss

Connect the Flexible Board 
from 2-group Frame Assy.

wa

With four bosses fitted in position, install Zoom Gear Block.

ws

Tighten one screw.
* Tightening torque = 0.068 

± 0.01N • m (0.7 ± 0.1kgf • cm)

Front Side

Rear Side

Screw

Zoom Gear Block

Bosses

Bosses

wd

Hook the Spring.

wg

Perform the Flange Back Adjustment after the assembling.

wf

Stick the Close Hole Tape.

Close Hole Tape

Spring

Tweezers

Inspect it as follows when you exchange parts in the lens block.
1

Zoom motion (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
No abnormal sound or motion must be found over full stroke between TELE end and WIDE end.

2

Zoom image
No abnormality such as a skipped image or wavy image must be found in the image through LCD or finder over full stroke between
TELE end and WIDE end.

3

Barrier (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
The barrier must be opened and closed fully, free from a sticking in the midway.
No abnormal sound must be heard during the operation.

4

Appearance condition
Scratches or stains must not be noticeable, except that the customer permits them.

5

Foreign matters on the lens
The lens condition must not be worse than that when the camera was received from the customer.

Lens at TELE end

Lens at WIDE end

Upward

Downward

Horizontal

Full stroke check