Read Sony DSC-W130 (serv.man2) Service Manual online
2-10
DSC-W130_L2
Check if the hook fits with the shaft
Check if the shaft fits with the groove.
5
qa
Claw
0
Molds
4
Screw
7
Screw
3
Optical Stepping Motor
2
Check the state of each part
1
Solders
9
Connector
8
Zoom Gear Block
6
Lens Rear Block
Lens Rear Block
Installation
1
Install the lens flexible board with four solders.
2
Referring to the following figure, check each part state of lens rear block.
3
Install Optical Stepping Motor.
4
Tighten one screw.
*
*
Tightening torque = 0.049
±
0.01N
•
m (0.5
±
0.1kgf
•
cm)
5
Rotate the gear of lens barrel in arrow direction to extend the lens.
6
Check the inside of lens barrel and the lens for dust or stain, and then install the lens rear block.
7
Tighten three screws.
*
*
Tightening torque = 0.049
±
0.01N
•
m (0.5
±
0.1kgf
•
cm)
8
Install Zoom Gear Block by referring to the installation 4 to 6 in "2-5-1. Zoom Gear Block Replacing Method".
9
Connect the connector of lens flexible board.
0
Assemble the lens flexible board with the mold of Lens Block.
qa
Engage the lens flexible board with the claw.
Click on the first or last page to see other DSC-W130 (serv.man2) service manuals if exist.