DSC-T5 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 8

2-1

DSC-T5_L2

• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.

Do not insert the cable insufficiently nor crookedly.

• When remove a connector, dont’ pull at wire of connector. It is possible that a wire is snapped.

• When installing a connector, dont’ press down at wire of connector.

It is possible that a wire is snapped.

• Do not apply excessive load to the gilded flexible board.

Cut and remove the part of gilt 
which comes off at the point.
(Be careful or some 
pieces of gilt may be left inside) 

The charging capacitor (C005) of the ST-126 board is charged
up to the maximum 300 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand.  The electric shock is caused by
the charged voltage which is kept without discharging when the
main power of the unit is simply turned off.  Therefore, the
remaining voltage must be discharged as described below.

To preparing the short jig, a small clip is attached to each end of
a resistor of 1 k

Ω

 /1 W (1-215-869-11).

Wrap insulating tape fully around the leads of the resistor to
prevent electrical shock.

1 k

Ω

/1 W

Wrap insulating tape.

Note: High-voltage cautions

Discharging the Capacitor
Short-circuit between the two points with the 
short jig about 10 seconds.

R:1 k

Ω

/1 W

 

(Part code: 
1-215-869-11)

Two soldering

Flat table

Speaker (SP901)

SW-455 flexible board

SW-455 flexible board

Speaker (SP901)

Horizontal

Put the speaker (SP901) and SW-455 flexible board on a flat
table when you solder.
It is important that each back become the horizontal.