DSC-T20, DSC-T20HDPR, DSC-T25 (serv.man4) - Sony Digital Camera Service Manual (repair manual). Page 37

6-35

DSC-T20/T25_ADJ

The Automatic Adjustment Program sets the data for adjustment
before the adjustment starts. Accordingly, if the adjustment termi-
nates by an error, the data during the adjustment may be left in the
camera.
Note 1: With this data left in the camera, the camera will not op-

erate normally.

In this case, the [Release Data Setting] button is displayed in “red”
on the screen as shown figures below. Click the
[Release Data Setting] button to cancel the data setting. When the
data setting is cancelled, the button color becomes “white”.
Note 2: When “Data Save Error” occurred,  the [Release Data

Setting] button is displayed in “white”.
To cancel the data setting, perform it on the SeusEX Op-
eration screen. How to cancel the data setting is displayed
in the error message.

Symptom

data cannot be saved normally. (The data set-
ting during adjustment cannot be cancelled)

Cause

• Data writing to the flash memory failed.

• Connection is faulty.

• Power supply is not installed correctly.

Remedy

• On the SeusEX Operation screen, [Set] the

data to the pages and addresses displayed in
the message, and [Save] them. (Cancel manu-
ally the data setting during adjustment.)

• Check the connection.

• Install the power supply correctly.

How to cancel the data setting during 
adjustment is display here.