Read Sony DSC-T100 (serv.man4) Service Manual online
6-23
DSC-T100_ADJ
2.
Wide Limit Adjustment
Adjustment to remove variations at the wide end of the inner fo-
cus lens.
cus lens.
Adjustment Block
11
Adjustment Page
61
Adjustment Address
0F18, 0F19
2-1. Adjusting method when the lens is replaced:
Adjusting method:
Order Block
Page
Address
Procedure
1
11
61
0F18
Set the data. (Note)
2
11
61
0F19
Set the data. (Note)
3
Save the data.
4
Perform “Flange Back
Adjustment”.
Adjustment”.
Note:
The data of block: 11, page: 61, address: 0F18 and 0F19,
that are set in the Orders 1 and 2 as described above, are
shown on the data sheet supplied with the replacement lens
for repair.
Set the upper single byte of the 2-byte data shown on the
sheet to address: 0F19, and the lower byte of the data to the
address: 0F18.
that are set in the Orders 1 and 2 as described above, are
shown on the data sheet supplied with the replacement lens
for repair.
Set the upper single byte of the 2-byte data shown on the
sheet to address: 0F19, and the lower byte of the data to the
address: 0F18.
Fig. 6-1-20
Data for Block: 11,
Page: 61, Address: 0F18
Page: 61, Address: 0F18
Wide Limit Data (2-byte data)
Data for Block: 11,
Page: 61, Address: 0F19
Page: 61, Address: 0F19
XXXX
2-2. Adjusting method when replacement of lens is
not required and the SY-171 board is replaced:
When the data of block: 11, page: 61, address: 0F18 and
0F19 can be read from the defective SY-171 board be-
fore replacement, and both of the data are not “00”:
0F19 can be read from the defective SY-171 board be-
fore replacement, and both of the data are not “00”:
Adjusting method:
Order Block
Page
Address
Procedur
1
11
61
0F18
Set the previous data
2
11
61
0F19
Set the previous data
3
Save the data.
4
Perform “Flange Back
Adjustment”.
Adjustment”.
When the data of block: 11, page: 61, address: 0F18 and
0F19 can be read out from the defective SY-171 board
before replacing it, and both of the data are “00”:
0F19 can be read out from the defective SY-171 board
before replacing it, and both of the data are “00”:
1) Replace the lens with the replacement lens and perform “2-1.
Adjusting method when the lens is replaced”.
When the data of block: 11, page: 61, address: 0F18 and
0F19 cannot be read from the defective SY-171 board:
0F19 cannot be read from the defective SY-171 board:
1) Replace the lens with the replacement lens and perform “2-1.
Adjusting method when the lens is replaced”.
Click on the first or last page to see other DSC-T100 (serv.man4) service manuals if exist.