DSC-S80 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 8

1-4E

DSC-S80

When “FLASH error”  (Self-diagnosis Code  E : 91 : ** ) occurs, to prevent any abnormal situation caused by high voltage, setting of the
flash is changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Flash error code can be initialized by the operations on the Setup screen.

Initializes the setting to the default setting.

1

Select [OK] with v on the control button, then press z.
The message “Initialize all settings Ready?” appears.

2

Select [OK] with v, then press z.
The settings are reset to the default setting.

• Make sure that the power is not disconnected during resetting.

OK

See the following procedure.

Cancel

Cancels the resetting.

SH

CA

LCD panel

Width of Flexible Harness of LCD Panel

Rear View (when the rear cabinet assy is removed.)

SW-446 Board (Side B)

Narrow:

TYPE C

Wide: TYPE S

Mounted Parts

TYPE C

TYPE S

D004

—

Mount

D006

Mount

—

SH

CA

D004

D006

The LCD type can be discriminated with the mounted parts on the SW-446 board, or the width of flexible harness of LCD panel.

About SW-446 board and LCD panel, discriminate LCD type on the machine, and replace the same type.

Checking method:
1)

Refer to “SECTION 2 DISASSEMBLY” to remove the rear cabinet assy.

2)

Referring the following figures, each type is discriminated with the mounted parts on the SW-446 board, or the width of flexible cable
of LCD panel.

Model

DSC-S60

DSC-S80

DSC-S90

DSC-ST80

LCD type

TYPE C

TYPE C

TYPE C or TYPE S

TYPE C