DSC-S60, DSC-S80, DSC-S90, DSC-ST80 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 51

— 2 —

DSC-S60/S80/S90/ST80_L2

Part Number

Part Name

Quantity

1

2-891-376-01

MOTOR UINT, ZOOM

1

These parts are not prepared as service parts.
Recycle removed screws.

1

Remove solder of “Zoom motor terminal” (4 point).
* Be careful for terminal deformation and breaking of coil.

2

Remove two screws that fix “Motor Unit, Zoom”.
* Removed screws are recycled. Do not lose them.
* Lens barrel should not be pulled out.
* Do not touch the motor directly for preventing rust. (Use finger cot etc...)
* Be careful not to damage the appearance.

3

Confirming Zoom function manually.
3-1. Turn Lens gear to clockwise and poke put the lens barrel until the position of open lens barrier.
3-2. Turn to the lens barrel (outside) for TELE end and WIDE end for four or five times and then confirm no against force during stroke.
3-3. During the lens barrel stroke check, confirm the condition of lens gear if there is no deformation of damage.
3-4. If everything is OK, step forward to next.
* If found any problem until this point, it is impossible to repair ZOOM motor unit. Therefore, replace the lens block assembly.

1

not supplied (Note)

Zoom Motor Unit

Two Screws

Solder

Rotate lens barrel and stroke

Length of gear

All circumferences