View Sony DSC-S500 Service Manual online
mark 0 or dotted line with
mark 0 are critical for safety.
Replace only with part num-
marque 0 sont critiques pour la
Ne les remplacer que par une pièce
portant le numéro spécifié.
contact your local Sony Service Headquarter for the measures.
MANUAL 9-852-124-12 with this Manual.
converted to a 35 mm still camera)
F2.8 - 4.8
JPEG compliant, DPOF compatible
Movies: AVI (Motion JPEG)
“Memory Stick Duo” (with MagicGate/
“Memory Stick PRO Duo”
“MagicGate Memory Stick Duo”
2.5 m (19 3/4 inches to 98 1/2 inches) (W)/
approx. 0.5 m to 2.0 m (19 3/4 inches to 78
3/4 inches) (T)
Video signal: 1 Vp-p, 75
Audio signal: 2 V (at load impedance more
than 47 k
HR15/51:HR6 (size AA) Nickel-Metal
Hydride batteries (2) (not supplied), 2.4 V
ZR6 (size AA) Oxy Nickel Primary Battery
(2) (not supplied), 3 V
AC-LS5K AC Adaptor (not supplied), 4.2 V
(during shooting with the LCD screen on)
batteries and wrist strap, etc.)
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
connections. Check the entire board surface for solder splashes
"pinched" or contact high-wattage resistors.
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
of deterioration. Point them out to the customer and
recommend their replacement.
circuit board (within 3 times).
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
heated tip is applied for too long, so be careful!
Unleaded solder is more viscous (sticky, less prone to flow) than
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
Replace only with the same or equivalent type.
Memory ··········································································· 1-1
4-1-2. Front Block ··································································· 4-2
4-1-3. Main Frame Block ························································ 4-3