DSC-RX100 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 6

DSC-RX100_L2

1-3

When the CD-847 Flexible Board (Imager) is mounted to the lens, shift and tilt adjustment is made with Spacer Plates.
When removing the CD-847 Flexible Board, pay attention to the following.

(1)  When the lens is not replaced
 

Example: In the case of disassembly, cleaning, or replacement of the CD-847 Flexible Board (Imager)

•  Check and record the size of the built-in three Spacer Plates and store them so as not to lose them.
•  When assembling the CD-847 Flexible Board, be sure to install the Spacer Plates to their original locations.

Size

0.xx

Note
Be careful not to lose the Spacer Plates.
If any Spacer Plate is lost or their previous positions are not sure, repeatedly take a photo and check that there is no local defocus. 

is needed.

(2)  When the lens is replaced

•  Check the size of the built-in three Spacer Plates. If the thickness of a Spacer Plate is not 0.20, discard the Spacer Plate.
•  Prepare three Spacer Plates B (t = 0.2) (Sony Part No.: 4-410-540-01) and install them to the new lens.

0.20

When problems occur while the unit is operating, the self-diagnosis func-
tion starts working, and displays on the LCD screen what to do.
Details of the self-diagnosis functions are provided in the Instruction 
manual.

When problems occur while the unit is operating, the LCD screen shows 
a 4-digit display consisting of an alphabet and numbers, which blinks at 
3.2 Hz. This 5-character display indicates the “repaired by:”, “block” in 
which the problem occurred, and “detailed code” of the problem.

0 0

3 2

C

Repaired by:

Refer to “1-4-3. Self-diagnosis Code Tabl e”.

Indicates the appropriate

step to be taken.

E.g.
13 ....Format the “memory card”.
32 ....Turn on power again.

Block

Detailed Code

Blinks at 3.2 Hz

C : Corrected by customer

E : Corrected by service

engineer

LCD screen