DSC-QX10 - Sony Digital Camera Service Manual (repair manual). Page 27

DSC-QX10

4-9

Fold inside

Draw up

Claws

Sensors

OK

NG

FG Leaf
Spring

FG Leaf Spring

FG Leaf Spring

Claw

FPC Retainer

Z Retainer

Installation
1. Install the LF-139 Flexible Board to the DC Motor Worm Assy and solder the LF-139 Flexible Board at two locations.
2. Install the DC Motor Worm Assy to the Stationary Tube Assy with two screws.
3. Install the Gear Worm Wheel, Gear A, and Gear B.
4. Install the Rear Mirror Plate.

5. Install four screws and the Z Retainer. Tighten the screws in the order of numbers in the figure below.
6. Install the LF-139 Flexible Board.

7. Connect the two Flexible Boards to the Connectors on the LF-139 Flexible Board.
8. Stick the FPC Tape as shown in the figure below.
9. Install the two Sensors and attach the FG Leaf Spring.
    Note: Attach the FG Leaf Spring in the correct orientation.

10. Attach the FPC Retainer.

1

2

3

4

Screws

Screws

Screw

Sensor

LF-139 Flexible Board

LF-139 Flexible Board

Flexible Board

Flexible Board

FPC Tape

FPC Tape

Rib

Connector

Connector

Gear A

Gear B

Gear Worm
Wheel

Rear Mirror
Plate

DC Motor Worm Assy

Solders

Ribs

Rib

Rib

Rib

Boss

Boss

Boss

Boss