Read Sony DSC-P41 / DSC-P43 (serv.man4) Service Manual online
DSC-P41/P43
6-13
1-4-3.
Adjusting Method
1.
CAMERA Adjustment 1
[Automatic Adjustment Program execution items and
sequence]
1. Data Setting during Camera Adj.
2. HALL Adj.
3. Flange Back Adj.
4. Release of Data Setting during Camera Adj.
sequence]
1. Data Setting during Camera Adj.
2. HALL Adj.
3. Flange Back Adj.
4. Release of Data Setting during Camera Adj.
[Adjusting method]
1) Click the
1) Click the
[CAMERA Adjustment 1 Start]
button.
2) The Automatic Adjustment Program executes “1. Data Setting
during Camera Adj.” and “2. HALL Adj.”.
3) Upon successful completion of the “2. HALL Adj.”, the fol-
lowing message is displayed. Set the subject by referring to
“Preparation of Flange Back Adj.”.
“Preparation of Flange Back Adj.”.
Fig. 6-1-15
4) If the
[OK]
button is clicked, “3. Flange Back Adj.” and “4.
Release of Data Setting during Camera Adj.” will be executed.
5) Upon successful completion of all items of the CAMERA
Adjustment 1, the following message is displayed. Click the
[OK]
button.
Fig. 6-1-16
Preparation of Flange Back Adj.
1) The minipattern box is installed as shown in the following fig-
1) The minipattern box is installed as shown in the following fig-
ure.
Note:
The attachment lenses are not used.
2) Install the minipattern box so that the distance between it and
the front of lens of camera is less than 3 cm.
3) Make the height of minipattern box and the camera equal.
4) Check the output voltage of the regulated power supply is the
4) Check the output voltage of the regulated power supply is the
specified voltage
± 0.01 Vdc.
5) Check that the center of Siemens star chart meets the center of
shot image screen with the zoom lens at TELE end and WIDE
end respectively.
end respectively.
Specified voltage: The specified voltage varies according to the
minipattern box, so adjustment the power sup-
ply output voltage to the specified voltage writ-
ten on the sheet which is supplied with the mini-
pattern box.
ply output voltage to the specified voltage writ-
ten on the sheet which is supplied with the mini-
pattern box.
Fig. 6-1-17
Minipattern box
Below 3 cm
Camera
Red (+)
Black (–)
Yellow (SENS +)
White (SENS –)
Black (GND)
Need not connected
Regulated power supply
Output voltage : Specified voltage
±
0.01 Vdc
Output current : more than 3.5 A
Click on the first or last page to see other DSC-P41 / DSC-P43 (serv.man4) service manuals if exist.