Read Sony DSC-HX10 / DSC-HX10V (serv.man2) Service Manual online
DSC-HX10/HX10V_L2
1-16
1
2
Screw
FG Plate Spring
Boss
Claw
wa
ws
wd
wf
Apply solder at two points and insert the two sensors into the Gear Case Assy.
Install the FG Plate Spring while locking the claw and the boss.
Install the Gear Case Assy to the camera body and tighten a screw.
*Tightening torque = 0.05
Install the FG Plate Spring while locking the claw and the boss.
Install the Gear Case Assy to the camera body and tighten a screw.
*Tightening torque = 0.05
±
0.01 N.m (0.51
±
0.1 kgf cm)
Gear Case Assy
Solders
Sensors
Sensors
Flexible board
Flexible board
Lands
Lands
wg
wh
Clamp the Flexible Board with the groove, claw, and boss.
Connect the Flexible Board to the connector.
Connect the Flexible Board to the connector.
wj
Attach the Flexible Board Retainer by inserting the projection and then locking the claw.
Flexible board
Flexible board
Groove
Boss
Claw
Claw
Hole
Projection
Hole
Flexible Board Retainer
1-11. FINAL INSPECTION
1-11-1. Confirm There is No Fault in Actual Motion/Actual Screen
Lens at TELE end
Lens at WIDE end
Upward
Downward
Horizontal
Full stroke check
Inspect it as follows when you exchange parts in the lens block.
1
1
4
Zoom motion (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
No abnormal sound or motion must be found over full stroke between TELE end and WIDE end.
Zoom image
No abnormality such as a skipped image or wavy image must be found in the image through LCD or finder over full stroke between
TELE end and WIDE end.
Barrier (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
The barrier must be opened and closed fully, free from a sticking in the midway.
No abnormal sound must be heard during the operation.
Appearance condition Scratches or stains must not be noticeable, except that the customer permits them.
Foreign matters on the lens The lens condition must not be worse than that when the camera was received from the customer.
No abnormal sound or motion must be found over full stroke between TELE end and WIDE end.
Zoom image
No abnormality such as a skipped image or wavy image must be found in the image through LCD or finder over full stroke between
TELE end and WIDE end.
Barrier (Check five postures: horizontal, upward/downward, upper/lower oblique 45º)
The barrier must be opened and closed fully, free from a sticking in the midway.
No abnormal sound must be heard during the operation.
Appearance condition Scratches or stains must not be noticeable, except that the customer permits them.
Foreign matters on the lens The lens condition must not be worse than that when the camera was received from the customer.
5
2
3
Click on the first or last page to see other DSC-HX10 / DSC-HX10V (serv.man2) service manuals if exist.