DSC-HX1 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 5

1-1

DSC-HX1_L2

When you replace to the repairing board, get the acquire data from the former needed for the adjustment from.
Start the Adjust Manual in the Adjust Station and perform “Restore Data” to get the data.
The data getting for this model is as follows.

• USB Serial No.

• Angular Velocity Sensor Sensitivity Adjustment (Dp/Dy Data)

• Wide Limit Adjustment

When you cannot read data from the former replace the same time SY-218 board and lens.

When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the “Destination Data Write”.

The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the “USB Serial No. Input”.

When you replace to the repairing board, write down the sensitivity displayed on the angular velocity sensor (SE401, SE402).
Start the Adjust Manual in the Adjust Station and execute the “Angular Velocity Sensor Sensitivity Adjustment”, input the data written down.

The sensor sensitivity of SE401, SE402 of SY-218 board are written only repair parts.

The wide limit data of lens is written only repair parts.

SE401

SE402

PP

YY

PP : PITCH sensor sensitivity

YY : YAW sensor sensitivity

When replacing the lens, write down the wide limit data given on
the lens for service.
Start the Adjust Manual in the Adjust Station and execute the “Wide
Limit Adjustment”, input the data written down.

XXXX

Wide Limit Data (2-byte data)

XX XX