DSC-H5 (serv.man13) - Sony Digital Camera Service Manual (repair manual). Page 26

6-24

DSC-H5_ADJ

Perform this adjustment only when replacing the angular velocity
sensor. When the microprocessor, circuit etc. is damaged, don't per-
form this adjustment but check the operations only.

Note down the sensitivity displayed on the angular velocity sensor of
the repair parts. At this time, note down also to which board it was
attached to.
Be sure to check because if attached incorrectly, the screen will vi-
brate up and down or left and right during the steady shot operations.

The PITCH sensor and the YAW sensor are different parts.

The sensor incorporates a precision oscillator. Handle it with care as
if it dropped, the balance of oscillator will be disrupted and opera-
tions will not be performed properly.

Adjustment Page

CF

Adjustment Address

0C, 0D

The sensor sensitivity of SE501 and SE502 of the SY-
150 board is written only repair parts.

Preparation:
1) Read the PITCH sensor (SY-150 board SE501) sensitivity writ-

ten on repair parts, and named this as S

501

.

2) Read the YAW sensor (SY-150 board SE502) sensitivity writ-

ten on repair parts, and named this as S

502

.

SE501

SE502

SY-150 BOARD (SIDE A)

XX

XX

YAW sensor sensitivity    

t

 S

502

PITCH sensor sensitivity 

t

 S

501

[Adjusting method]
1) Click the [Start] button of Camera Adjustment 7, and the fol-

lowing screen will appear.

2) Input the sensitivity of respective sensors (S

501

, S

502

) read at

“Preparation” into the screen.
If only either sensor was replaced, give a check to the checkbox
for the sensor not replaced at the lower left of the screen.

3) Click the [OK] button, and the adjustment data is then calcu-

lated from the sensor sensitivity value and the calculation re-
sult is written to the memory in the camera.

4) Upon successful completion of the data writing, the following

screen will appear. Check that the steady shot function oper-
ates normally.