DSC-H3 (serv.man4) - Sony Digital Camera Service Manual (repair manual). Page 21

6-20

DSC-H3_ADJ

Perform this adjustment only when replacing the lens block or
SY-185 board.

Adjustment Block

11

Adjustment Page

61

Adjustment Address

0F18, 0F19

2-1. Preparation when the lens is replaced
When replacing the lens, write down the wide limit data given on
the data sheet of the replacement lens for service.
Note: The wide limit data of lens is written only repair parts.

2-2. Preparation when the SY-185 board is replaced
Read out the previous data by using the [Save] button of the auto
adjustment program.
Note: If correct data reading failed, replace the lens together with

the SY-185 board.

Wide Limit Data (2-byte data)

XXXX

XXXX

2-3. Wide Limit Adjustment
[Adjusting method]
1) Click the [Start] button of Camera Adjustment 2, and the fol-

lowing screen will appear.

The buttons on this screen provide the following functions.
[Read    Save] button
• Saves the wide limit data (2-byte data) read out from the set into

a file.

• Displays a “Wrong Data Error” message if the data value is not

correct.

• Default file name is as follows:

[Load    Write] button
• Writes the wide limit data (2-byte data) read out from the file

into the camera memory.

• Displays a “Wrong Data Error” message if the value read out

from the file is not correct.

[Manual Write] button
• Writes the entered wide limit data (2-byte data) into the camera

memory.

• Displays a “Wrong Data Error” message if the input value is

not correct.

2) When the lens was replaced, enter the wide limit data given on

the data sheet of the replacement lens for service into the screen,
and press the [Manual Write] button.

3) When the SY-185 board was replaced, press the [Load and Write]

button.

4) Upon successful completion of the data writing, the following

screen will appear.
Perform the Flange Back Adjustment.

DSC-H3_WLIMIT_xxxxxxxx_yyyymmdd.dat

Date
USB serial number
Data name

&

&