Read Sony DSC-H20 (serv.man2) Service Manual online
mark 0 or dotted line with
mark 0 are critical for safety.
Replace only with part num-
marque 0 sont critiques pour la
Ne les remplacer que par une pièce
portant le numéro spécifié.
SERVICE MANUAL 9-852-683-31
with this manual.
While shooting movies (4:3): 47 mm
2.21, MPF Baseline) compliant, DPOF
Movies: MPEG4 Visual
Approx. 0.2 m to 7.0 m (7 7/8 inches to
22 feet 11 5/8 inches) (W)/
approx. 0.9 m to 5.5 m (2 feet 11 1/2 inches to
18 feet 5/8 inches) (T)
Audio output (Stereo)
NP-FG1 (sold separately), 3.6 V
AC-LS5K AC Adaptor (sold separately),
PRINT Image Matching III: Compatible
Nominal voltage: DC 3.6 V
Maximum charge voltage: DC4.2 V
minimum: 3.3 Wh (910 mAh)
change without notice.
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
connections. Check the entire board surface for solder splashes
“pinched” or contact high-wattage resistors.
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
of deterioration. Point them out to the customer and
recommend their replacement.
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
• Unleaded solder melts at a temperature about 40
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
heated tip is applied for too long, so be careful!
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
also be added to ordinary solder.
Replace only with the same or equivalent type.
Dispose of used batteries according to the instructions.
Start the Adjust Manual in the Adjust Station and perform “Restore Data” to get the data.
The data getting for this model is as follows.
Start the Adjust Manual in the Adjust Station and execute the “Destination Data Write”.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the “USB Serial No. Input”.
Start the Adjust Manual in the Adjust Station and execute the “Angular Velocity Sensor Sensitivity Adjustment”, input the data written down.