XTL-W7000 - Sony Car Audio Service Manual (repair manual). Page 7

7

Film antenna qf

Antenna input
cable qg

TV
antenna
amplifier
unit qd

Tap 7

To a car’s illumination signal *

2

Tap 7

*1 An adaptor (optional) may be necessary for your car and

car audio system. In such case, consult your dealer.

*2 First connect the black ground lead, then connect the

orange/white striped, yellow and red power input leads.

from a car antenna *

1

Antenna connector *

1

Film antenna qf

Antenna input
cable qg

TV
antenna
amplifier
unit qd

To a car’s illumination signal *

2

2

3

Sony BUS Master-unit (equipped
with the TV control function) *

1

*1 Sony BUS  Master-unit (equipped with the TV control

function) will come in 2005.

*2 First connect the black ground lead, then connect the

orange/white striped, yellow and red power input leads.

Tap 7

Tap 7

The unit should be installed within an
angle of 30 degrees from horizontal. If
this angle is exceeded, the monitor may
not open up or retract properly.

Keep the units and connection cables
apart.
The TV main unit and the amplifier unit
qd

 should not be in close proximity.

2 Installing the Main Unit

After all connections are made, install the main unit to the
dashboard.

This unit is designed to be completely safe, but if not installed
correctly, it can cause accidents. Be sure to verify the following
points before installation.
Install the main unit to the in-dash location, and the amplifier unit
under the navigator’s seat, etc.
• If the monitor in the opened position is close to a air-

conditioning outlet, the outlet should be closed.

• Install the unit so that the monitor when opened up will not

block access to the hazard switch or other important controls.

• Do not install the unit (monitor) in locations which may be

subject to excessively low or high temperatures. (Otherwise the
unit may be deformed and the LCD may be damaged.)
Exposure to direct sunlight can also lead to high temperatures
and should be avoided.

• Perform the installation carefully. Dropping the unit or

otherwise subjecting it to strong impact or force may deform
the chassis, resulting in failure of the monitor loading
mechanism or other defects.

N

N

T

T

N

T/N

T/N T/N

T

• To allow for proper opening and closing of the monitor, there

must be a clearance of at least 167 mm between the closest
position of the shift lever and the mounting surface for the unit.

• In some cases, the shift lever may touch the monitor when

moved to a certain position. Make sure that there is no
obstruction to driving operations.

• When installing this unit together with other car audio

equipment (single DIN slot size) in a stacked configuration,
install the TV main unit on top.

Before installing the unit, remove the bracket from the unit.

Insert two release keys qa together into the unit
and the bracket 8 until they click.

Pull down the bracket 8, then pull up the unit to
separate.

m

,

8

qa