Read Sony XTL-6100 (serv.man2) Service Manual online
– 3 –
– 4 –
RGB Decoder FO Adjustment
Procedure:
1. Without INPUT1, INPUT2 inputs (no signal input mode), short
1. Without INPUT1, INPUT2 inputs (no signal input mode), short
the jumper wire between TP100 and GND.
2. Connect a frequency counter to TP61.
3. Adjust VR6 so that reading on frequency counter is
3. Adjust VR6 so that reading on frequency counter is
4.433619 MHz
±
10 Hz.
4. Short the jumper wire between TP106 and GND.
5. Connect a frequency counter to TP61.
6. Confirm that reading on frequency counter is 3.579545 MHz
5. Connect a frequency counter to TP61.
6. Confirm that reading on frequency counter is 3.579545 MHz
±
100 Hz.
7. After this adjustment, remove the jumper wires.
RGB Decoder Input Level Adjustment
Procedure:
1. Input signal : PAL EBU color bar (INPUT 1 VIDEO)
2. Adjust VR4 so that the white peak 1 (100% white) of
1. Input signal : PAL EBU color bar (INPUT 1 VIDEO)
2. Adjust VR4 so that the white peak 1 (100% white) of
TP111 (B OUT) is at 1.0 Vp-p.
DL AMP & DAT Adjustment
Procedure:
1. Adjust DAT so as to minimize the variation between the level
1. Adjust DAT so as to minimize the variation between the level
2 and the level 3 of TP111.
2. Adjust VR5 so that the blue level 4 is at 1.0 Vp-p.
3. Set the input to NTSC, and confirm that the blue level 4 is at
3. Set the input to NTSC, and confirm that the blue level 4 is at
1.0
±
0.1 Vp-p.
T3: VCO Adjustment
: AFT Adjustment
: AFT Adjustment
VR1: AGC Adjustment
T2: TRAP Adjustment
T1: TRAP Adjustment
VR5: DL AMP & DAT Adjustment
VR6: RGB Decoder FO Adjustment
VR4: RGB Decoder
input Level Adjustment
input Level Adjustment
TP100
TP106
TP111
TP61
TP102
TP42
TP30
TP34
TP33
TP31
white
blue
SYNC
TP111
1
2
4
3
white
blue
SYNC
TP111
1
2
4
3
Connection Points and Adjustment Points:
Click on the first or last page to see other XTL-6100 (serv.man2) service manuals if exist.