Read Sony XR-CA360EE Service Manual online
22
XR-CA360EE
Pin No.
Pin Name
I/O
Description
50
ATT
O
Audio line muting on/off control signal output “H”: muting on
51 to 53
NC
O
Not used
54
TU-ATT
O
Tuner muting on/off control signal output to the tuner unit “L”: muting on
55, 56
NC
O
Not used
57
LO/DX
O
Local/DX selection signal output terminal “L”: DX, “H”: local Not used
58
TU-ON
O
Tuner system power supply on/off control signal output “H”: tuner power on
59
VOL-ATT
O
Electrical volume muting on/off control signal output to the electrical volume “L”: muting on
60
FM-ON
O
FM system power supply on/off control signal output terminal
“H”: FM power on Not used
“H”: FM power on Not used
61
AM-ON
O
AM system power supply on/off control signal output terminal
“H”: AM power on Not used
“H”: AM power on Not used
62
NC
O
Not used
63
LCD-RES
O
LCD reset signal output to the liquid crystal display driver “L”: reset
64
LCD-CE
O
Chip enable signal output to the liquid crystal display driver “H” active
65
FLASH-W
I
Internal flash memory data write mode detection signal input
“L”: data write mode Normally: fixed at “H”
“L”: data write mode Normally: fixed at “H”
66
TEST-IN
I
Setting terminal for the test mode “L”: test mode Normally: fixed at “H”
67 to 73
NC
O
Not used
74
EE-SIO
I/O
Two-way data bus with the tuner unit
75
EE-CKO
O
Serial data transfer clock signal output to the tuner unit
76
COL-SEL
I
Illumination color selection signal input “L”: red illumination “H”: green illumination
(fixed at “H” in this set)
(fixed at “H” in this set)
77 to 82
NC
O
Not used
83
ILL-ON
O
Power on/off control signal output of the illumination LED and LCD back light
“H”: power on
“H”: power on
84
DEST-SEL0
I
Destination setting terminal (fixed at “L” in this set)
85
DEST-SEL1
I
Destination setting terminal (fixed at “L” in this set)
86
DEST-SEL2
I
Destination setting terminal (fixed at “L” in this set)
87 to 92
NC
O
Not used
93
NOSE-SW
I
Front panel block remove/attach detection signal input
“L”: front panel is attached
“L”: front panel is attached
94
NS-MASK
O
Not used
95
DAVSS
—
Ground terminal (for D/A converter)
96
TAPE-ON
O
Capstan/reel motor drive signal output “H”: motor on
97
N/R
I
Tape direction switch input terminal “L”: reverse direction, “H”: forward direction
98
FF/REW
I
FF/REW detection switch input terminal “L”: FF/REW mode, “H”: PLAYBACK mode
99
TAPE-IN
I
Tape in detection switch input terminal “L”: tape in
100
DAVDD
—
Power supply terminal (+5V) (for D/A converter)
Click on the first or last page to see other XR-CA360EE service manuals if exist.