Read Sony XR-CA360 / XR-CA360X Service Manual online
2
XR-CA360/CA360X
1
DIAGRAMS
1-1.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Schematic Diagram:
• All capacitors are in
• All capacitors are in
µ
F unless otherwise noted. pF:
µµ
F
50 WV or less are not indicated except for electrolytics
and tantalums.
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
C
: panel designation.
•
A
: B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : FM
no mark : FM
〈〈
〉〉
: TAPE PLAYBACK
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
f
: AM
E
: TAPE PLAYBACK
L
: BUS AUDIO IN
• Abbreviation
EA
: Saudi Arabia model
• When replacing the IC1, refer to servicing note (Page 2
“When replacing the IC1”).
Note on Printed Wiring Board:
•
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
z
: Through hole.
•
: Pattern from the side which enables seeing.
•
: Carbon pattern.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• Abbreviation
EA
: Saudi Arabia model
• When replacing the IC1, refer to servicing note (Page 2 “When
replacing the IC1”).
Click on the first or last page to see other XR-CA360 / XR-CA360X service manuals if exist.